I’m doing a power supply repair on a Sony car amp, original parts was K2902 mosfet 6pcs with 10ohms gate resistors, I can’t get these (in my country) I want to use subbed part, what is a simple drop in for this amp I’m already prepared to used insulators and washers for any tabbed (TO220) devices. With the 10ohms gate (I was eyeing the 3205 with the 47ohms but didn’t want to remove those resistors) could the 1010E be used with same gate resistors?
The K2902 is rated 60v @45A
The K2902 is rated 60v @45A
Attachments
I couldn't find a datasheet on the drivers. The 1010s would be slightly easier to drive.
Whatever you use, confirm that they run cool at full duty cycle.
Whatever you use, confirm that they run cool at full duty cycle.
Found these specs in a lineup publication:
2SC6027 (NPN)
Package: MPT3
BVceo: 30
Ic(A): 1
Icp(A): 2
hfe: 120-390
ton: 30/30
tstg: 100-120
tf: 20-35