TAS5611 power supply

[ambisingh]

Hi i just brought a TAS5611 chip amp as i want to have a go at using a class d chip amp. It is for a pair of seas mimir . The question i wanted to know is how do i go about the power supply to power it can i use a 36v smps or does anyone have a idea on what i need to do

i am a begginer when it comes to the chip amps so sorry if these questions seem odd

Thanks

 

[JonSnell Electronic]

You can go as high as 48V or as low as 30V and it should be fine.

 

[ambisingh]

What kind of amperage should i be looking for or does that not matter ?

 

[JonSnell Electronic]

I would look for 10Amps at 32Volts.

 

[ambisingh]

hi does anyone know where i can buy the 3 pin adaptor that is used on the input section so far i have soldered the rca wires directly on the board but i would rather get the adaptor

Thanks

 

[Buehgemeiste]

my 5611 works well with voltages as low as 20v.
i guess even 12v would be ok.

 

[cyteen]

For the input connector:

If you want to make your own then search for XH2.54-3P on ebay:
XH2.54-2P 3P 4P 5P 6P 2.54MM CONNECTORS SETS - SOCKET + PLUG + TERMINAL | eBay

If you want pre-made:
Yuan Jing Audio - Shielded Inter-Connection Audio Cable JST-XH-2.54-3P AWG24 - USD $0.80 - Connectors

 

[ambisingh]

For the input connector:

If you want to make your own then search for XH2.54-3P on ebay:
XH2.54-2P 3P 4P 5P 6P 2.54MM CONNECTORS SETS - SOCKET + PLUG + TERMINAL | eBay

If you want pre-made:
Yuan Jing Audio - Shielded Inter-Connection Audio Cable JST-XH-2.54-3P AWG24 - USD $0.80 - Connectors

Thanks for the help