500W PA amplifier with Limiter

[fhoenix]

thanks u sir andrewlebon

 

[sarbini]

🙂😀😉

 

[gede]

Hello Mr. Liem Poo.... this file is password protected... can you share password.

Thanks & Regards

 

[danzrose]

my b600 but not finished.

 

[nano nano]

very nice work

 

[apexaudio]

my b600 but not finished.

Nice work, thanks for shareing,
Regards

 

[Le Thien Thanh]

Connection A B Is What .?

 

[jaagut]

Connection A B Is What .?

for bridged-tied load set-up.

 

[gantex]

my b600 but not finished.

nice layout 😉, thanks for sharing. maybe u will make next layout with TEF triple darlington or maybe H classes 😀.

 

[wattaniya]

hi apex sir,
can u tell me what is the output ac volt for 3200w?

 

[AndrewT]

You can work it out from
P = IV = I²R = V²/R
V = sqrt(P*R)

 

[jaagut]

let's calculate using formulas given by AndrewT,

P = 3200W rms

let's say we will use 8 ohms speaker,

V = sqrt(3200*8) = 160V rms

for 4 ohms speaker,

V = sqrt(3200*4) = 113V rms

 

[Shelah]

Hello sir apex, can the h-step driver used to turn an mosfet ampifier like hv23 to class h?

 

[drauns]

thanks apex

 

[apexaudio]

thanks apex

is this pcb tested?

 

[Techpolice]

hello apex audio
what balance input preamp can you recommend for b500?
when bridging 500,should i just left the chanel b input floating or should i connect it to gnd?

 

[Techpolice]

hi Apex
what balance line preamp can you recommend for b500
in bridging b500,should i just left the input floating on ch 2 or should i connect it to gnd?

 

[desislavov]

hello party people !
Is there pdf or lay file for B500 ?
I have all parts , but no PCB .
I will post pictures after soldering ....
Please , help .
Regards!

 

[desislavov]

i found zip at post 2305 .
Is this is working PCB ?
Regards !

 

[vdij]

desislavov, take.