Hi all,
I'm looking to do a little DIY modding on a really nice Luxman integrated amp and this looks like the perfect site to start learning. I'm not an electrical engineer but a physicist so the circuit analysis stuff isn't my strong suit. At any rate, If there's anybody here in Dallas, particularly TI (Texas Instruments) who might provide some guidance I'd appreciate it. In the meantime I look forward to participating and learning here.
Cheers,
Matt
I'm looking to do a little DIY modding on a really nice Luxman integrated amp and this looks like the perfect site to start learning. I'm not an electrical engineer but a physicist so the circuit analysis stuff isn't my strong suit. At any rate, If there's anybody here in Dallas, particularly TI (Texas Instruments) who might provide some guidance I'd appreciate it. In the meantime I look forward to participating and learning here.
Cheers,
Matt
Welcome to the forum Matt.
Have a look around the Solid State Amp threads, then you might want to post your request over there.
The more specific you are about what you want to do, the more help you'll get.
Have fun!
Have a look around the Solid State Amp threads, then you might want to post your request over there.
The more specific you are about what you want to do, the more help you'll get.
Have fun!
Hi,
Thanks for the response. I'm trying to troubleshoot what appears to be a bad output in the preamp section of an integrated amp. I'm guessing it may be cap related but I have no experience troubleshooting or replacing. I think I have the schematic. Is this something you have any experience with? Thanks and I look forward to talking with you.
Matt
- Status
- Not open for further replies.