Jim
I am using the BA3 paired with the Aleph J currently running the FH on Alpair 7p. Currently in the process of building the VFET2 kit and should be up and running in couple of months time. BA3 pairs well with Aleph and I hope it should be the same with VFET as well.
Thanks
I am using the BA3 paired with the Aleph J currently running the FH on Alpair 7p. Currently in the process of building the VFET2 kit and should be up and running in couple of months time. BA3 pairs well with Aleph and I hope it should be the same with VFET as well.
Thanks
I have to agree with .Mara, I built the DCG3 and it is superb.Check out the Salas DCG3. Superb performance.
Thanks guys.
I've been pondering the BA-3 pre for a while but am intrigued by the DCG3.
Marra can you expand a little on your review?
Appreciate the input
PM sent.
Has anyone felt the need for including one of the Velleman (or equiv.) speaker protection kits with this amp?
I wish I had the solder-slingin' skills you folks have, but since I don't I'm having someone else build mine now - and this question was posed by the builder.
Thanks!
I wish I had the solder-slingin' skills you folks have, but since I don't I'm having someone else build mine now - and this question was posed by the builder.
Thanks!
Attachments
Sorry, but all the VFET kits are long gone..
Hello guys
Can you still buy kit ??
Okay - I got the amp from my builder and it's been warming up for about 45 minutes with no speakers connected. The builder suggested testing the DC offset before I start using it.
Scratch that - I'm an idiot. My multimeter was set up for Vac, not Vdc.
Re-checked it at the speaker terminals and got ~51 mVdc on the left channel, ~26 mVdc on the right channel. I really don't want to mess with the P3/P4 pots, I'm sure I'll screw it up. Am I good to go?
Any other test points I should check to make sure nothing got bumped the wrong way in transit?
Thanks!
Scratch that - I'm an idiot. My multimeter was set up for Vac, not Vdc.
Re-checked it at the speaker terminals and got ~51 mVdc on the left channel, ~26 mVdc on the right channel. I really don't want to mess with the P3/P4 pots, I'm sure I'll screw it up. Am I good to go?
Any other test points I should check to make sure nothing got bumped the wrong way in transit?
Thanks!
Last edited:
Okay - I got the amp from my builder and it's been warming up for about 45 minutes with no speakers..
Re-checked it at the speaker terminals and got ~51 mVdc on the left channel, ~26 mVdc on the right channel. I really don't want to mess with the P3/P4 pots, I'm sure I'll screw it up. Am I good to go?
Thanks!
Fire that mommy dearest up!
- Home
- Amplifiers
- Pass Labs
- Sony VFET Amplifier Part 2