Good news: today arrived the 8 caps 0,1uF/600V russians teflon T-3, wow are terribly bigs comparing with the 0,1uF/200V russians teflon T-2.
Now only need to measure all caps & I will start mine Simplistic:=)
An externally hosted image should be here but it was not working when we last tested it.
Now only need to measure all caps & I will start mine Simplistic:=)
Last edited:
Only for fun, pic with measured FT-3
An externally hosted image should be here but it was not working when we last tested it.
Hi guys,After having recently revived my 30 year old Logic DM101 I've been scanning this thread for a few days now, only got to page 230 and decided to take action, as I had most of the parts collecting dust.
Unfortunately I don't have enough K170s or the Mosfets for the shunt so I'll need to improvise to get this baby playin tunes.
No exotic caps or Rs yet as I need to test the water first so to speak before layin oot the dosh!
Anyway this is what I came up with.
Hi Ricardo Great work Hows it going? You got a scope yet?
Unfortunately I don't have enough K170s or the Mosfets for the shunt so I'll need to improvise to get this baby playin tunes.
No exotic caps or Rs yet as I need to test the water first so to speak before layin oot the dosh!
Anyway this is what I came up with.
Hi Ricardo Great work Hows it going? You got a scope yet?
Attachments
After all the past troubles, I am very carefull about solder joints
I finished building the two boards ! The psu is working very well.
Before I connect anything I must be sure there are no errors in the p2p.... It will take some time to compare the boards links with the schematic.
Tomorrow I will get the missing "tuning" caps.... finally I will work on the gnd and power connections.
I finished building the two boards ! The psu is working very well.
Before I connect anything I must be sure there are no errors in the p2p.... It will take some time to compare the boards links with the schematic.
Tomorrow I will get the missing "tuning" caps.... finally I will work on the gnd and power connections.
a ty-wrap.Since I'm using teflon sheets for my constructions I could heavily modify them converting them to Teflon and air dielectric ...
A good glue for teflon anyone ?
Hi Andrew,
I don't know about the system but I appreciate your generosity..
Hi Ricardo,
Read this page http://www.diyaudio.com/forums/power-supplies/143693-simplistic-salas-low-voltage-shunt-regulator-61.html#post1860076
I don't know about the system but I appreciate your generosity..
Hi Ricardo,
Read this page http://www.diyaudio.com/forums/power-supplies/143693-simplistic-salas-low-voltage-shunt-regulator-61.html#post1860076
No scope yet
The boards look good !
Nice work Ricardo
Very good components selection:
Resistors: 1 shinkoh, 1 Takman & the rest Kiwame?
Elec. Caps: BG NP, Elna Silmic II, Rubycon ZL?
Film Caps: Obbligato, Russian Silver Mica, Russian FT-3 teflon
What about how's sound?
Teflon board by Erno's Borbely:
An externally hosted image should be here but it was not working when we last tested it.
Last edited:
- Home
- Source & Line
- Analogue Source
- Simplistic NJFET RIAA