peranders said:Three different caps can fitted.
Left: Standard 10 mm pitch
Middle: Heavy duty low impedance BHC -RIFA
Right: Heavy duty general purpose BHC - RIFA
Those BHC caps seems to be a bit difficult, and expensive, to source in the U.S. Would that "Right: Heavy duty general purpose" footprint in post 302 happen to coincide with a 35mm diameter Panasonic T-UP 4-pin footprint?
peranders said:You can buy BHC from Farnell which you have in the US.
I think Panasonic had the same pinout. You only have to compare the datasheets.
Farnell doesn't have a US operation. It looks like Newark will post an order through them, but adds a $20 handling fee.
My first Panasonic data sheet didn't have pinout designations, but I was able to locate another one this morning. The BHC data sheet I have is a bit confusing to me, but I think it is not looking good for a match up.
Best or second best, there are no such things. Most parts which will fit will also work. The biggest trouble is the get the parts. The best you can do is to make a survey over availability.
Look for parts with similar parameters.
Look for good brands, ON, IR, NXP, Vishay, BHC, Panasonic, Rubycon, etc.
Look for parts with similar parameters.
Look for good brands, ON, IR, NXP, Vishay, BHC, Panasonic, Rubycon, etc.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Group Buys
- Power Amp PSU Board (for e.g. LYNX Amp)