Sure you should, they are a great bandThis is neat. Or should I say neat, neat, neat?
nAr, like your cabling. Nice amp too.
Thank you
[off_topic]Refering to cables, I now use the www 0,254mm as speaker wire One single solid core by polarity. Coupled to Mundorf low mass copper / berylium bananas. So far it sonically outperforms all I had in the system before; TNT multibraided, monacor multistrand, big diameter cables ... etc
May I attach a quick view of actual the setup
The UGS pre feeds the J monoblocs in balanced mode. Out of the J are the www wires linked to the speaker. Those wires are ... invisible [/off_topic]
Best,
nAr
Attachments
moi having the same
,25mm dia , Silvered solid core copper , one strand per polarity , ditto to posts (without any bananas)
16R/94db/W spks
Mine are 8 ohms circa 95 dB global ( compression driver is attenuated ) and those wires work wonders.
I added teh bananas not to break the tiny precious wire into the bindposts !!!!
Best,
nAr
0,25mm, really?
Are we talking diameter or area, and what the heck is www 0,25 wire?
Regards
It's definitely AWG30 WireWrap Wire
Section is : ¶(0,254/2)² = roughly 0,05 mm2
Regards,
nAr
What insulation did you use?
Regards
This www is Kynar insulated. Definitely better than PVC I guess.
I know Mouser sells some 32AWG mono strand silvered copper ptfe insulated.
Even more interesting for FCB (Fearless Cable Builders)
But it's a little (soooooooo much) off topic ...
Best,
nAr
- Home
- Amplifiers
- Pass Labs
- Pictures of your diy Pass amplifier