• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Jhofland’s Diamond Buffer GB

Jump to Latest
xrk971

xrk971

Founder of XSA-Labs
Joined 2012
etsy.com/shop/XRKAudio
Paid Member
Soundstage and stereo imaging are very dependent on isolation of the power supplies - if they are sharing a common single PSU there may be rail to rail crosstalk. Try adding a CRC (2200uF / 4.7R / 2200uF) for each buffer to help isolate them. Or get a dual mono PSU. Easier than a CRC, even adding 1000uF caps on each rail right near the buffer boards and a small series 2.2R to 4.7R between the PSU and the rail cap will make a big difference.

Hope that helps.
 
  • Like
Reactions: 1 user
You must log in or register to reply here.
Top Bottom