I started looking at an amp for a friend, it draws current but no fets are shorted? It had a blown in half diode d12 and four of the caps look swollen, d23 reads shorted in circuit.
15v 10amp. I'm tracing the outputstage now perry. Without the rectifiers in the amplifier, it no longer draws current. I should not have 10.8v on the gate leg of, one side of fets. I am looking at the driver board voltages now, shouldn't I have a +-15v going to the board?
I'm not familiar with this specific board but if it's like the larger boards, you will have +15, +5 and -5 and a 12v that is referenced to the negative rail.