Why do we have to go to Audiocircle to find the "best" assembly instructions?
What was Wushuliu thinking about?
To spread the word and encourage people who are not as familiar with the possibilities of DIY. Also, it's an easier forum to edit posts with fewer tangential distractions. What can I say, I'm a forum butterfly.
I didn't know full kits were being offered. Must resist!
Is there an picture of the PCB´s in the GB (prices)?
http://www.diyaudio.com/forums/group-buys/188974-gb-thread-salas-ssr1-1-bib-shunt-reg.html
Wush,
your link would be an excellent edit for the first post.
Tea b,
can you arrange that?
Good idea!
Done!
Yes I believe it does.
The cathode should go towards squared off part of the symbol drawn on the board.
The LEDS in general are ~1.8-2.0v tested. I would measure up as many as you can to add similar pairs to each side. so the sum total for each set of 5 matches up, then same for the 3 leds.
The cathode should go towards squared off part of the symbol drawn on the board.
The LEDS in general are ~1.8-2.0v tested. I would measure up as many as you can to add similar pairs to each side. so the sum total for each set of 5 matches up, then same for the 3 leds.