jacco,
Thank you for this vital info ...... just 30 years too late
Jacco est Wakoo
seems that you didn't received my e-mail ( there is always possibility that I send it from my hysteric account )
I was short in Shunty pcbs ; they'll be on my bench on Monday ( if Pony Express find a way through Serbian snow ) .......
Nirvana is near ...... (especially if you realize that you don't need gadgets for that )
seems that you didn't received my e-mail ( there is always possibility that I send it from my hysteric account )
I was short in Shunty pcbs ; they'll be on my bench on Monday ( if Pony Express find a way through Serbian snow ) .......
Yep, i haven't received it.....
Anyway, i am not in a hurry !
Manu, i am ordering the PSMLS PCB to try it as well.... But i am lazy and i need a motorized pot to control volume.
To change inputs, i have what i need, including relays.
too fat wires
too long , also
you need to keep them tiny and short - at least those for signal ;
that means - both selector and preciousssssssssss TKD must be mounted near back plate
if that's just for test - scusate ....
Yoda
Yes the pics reflects experimental state ....
So to speak ... because it already sounds fantastic as is
that means - both selector and preciousssssssssss TKD must be mounted near back plate
I ll do that when i finish shunty and can focus on optimal version ...
Concerning
all the credits go to MaguraSpaghetti Kunst
Manu
(padawan)
Manu, i am ordering the PSMLS PCB to try it as well....
I am tempted too ...
Manu
BTW Sasha : why you don't say "ugly"? ... Iznogoud, my Pumpkin ...?
Russel - just made them of Al sheet - 2 or 3mm thickness , use full height of case
heatsink's form/quality is less important then well ventilated case
But I wanted it to be unfugly! Seriously, how tall would the case have to be?
I may be getting some sinks from Conrad, perhaps they have them. The aluminum you suggest sure would be the easiest way.
Russellc
- Home
- Amplifiers
- Pass Labs
- Pumpkin preamp - ordered by Steen , official making thread