Hi all adn thanks in advance for you help
I am trying to bias a Dared vp16 integrated. I have done so in the past
with my cheapo multimeter.
I am getting a very consistent reading of .75 v at all check terminals.
it is supposed to be .25, and was last biased at .225 after i had it worked on
i have changed out a couple tubes to slightly stronger ones.
how could have it changed so much? it sure doesn't seem to be running
stupid hot or anything.
any comments would be appreciated.
I am trying to bias a Dared vp16 integrated. I have done so in the past
with my cheapo multimeter.
I am getting a very consistent reading of .75 v at all check terminals.
it is supposed to be .25, and was last biased at .225 after i had it worked on
i have changed out a couple tubes to slightly stronger ones.
how could have it changed so much? it sure doesn't seem to be running
stupid hot or anything.
any comments would be appreciated.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.