Hey guys, I recently decided to pull out a backburner project on a SPP build I started about 4 yes ago. I've gone through notes and pics I took, but have some questions on terminating everything.
I've started a mockup build and after a bunch of reading, and my brain hurting, I'm just looking for some basic 101 answers, please feel free to fill in the blanks
Power supply Edcor XPWR008-120
RED to T1-RED 01- 03
YELLOW to T1-YEL 01-02
RED/BLK to T1-RED-YEL 01
BLACK COMMON to TI GRN 02
BROWN to TI GRN 01
Choke Edcor CXC100 5H 200MA to L1 01-02
MOTOR RUN cap ???
Output transformer CXPP-MS-8K/23%
YELLOW WHITE-spkr out/common 8ohm
GRN, ORG- not used
Blue and brown- go where??
Wht/blue-screen and white/brown-screen go where??
Red B+ go where??
Based on my OPT C101 should be what values?
Anything else I'm overlooking?
Thanks
I've started a mockup build and after a bunch of reading, and my brain hurting, I'm just looking for some basic 101 answers, please feel free to fill in the blanks
Power supply Edcor XPWR008-120
RED to T1-RED 01- 03
YELLOW to T1-YEL 01-02
RED/BLK to T1-RED-YEL 01
BLACK COMMON to TI GRN 02
BROWN to TI GRN 01
Choke Edcor CXC100 5H 200MA to L1 01-02
MOTOR RUN cap ???
Output transformer CXPP-MS-8K/23%
YELLOW WHITE-spkr out/common 8ohm
GRN, ORG- not used
Blue and brown- go where??
Wht/blue-screen and white/brown-screen go where??
Red B+ go where??
Based on my OPT C101 should be what values?
Anything else I'm overlooking?
Thanks
Last edited: