• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

$600- 4x Acoustic Elegance TD15M in cabs

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
$500 for 4x TD15M 4 ohm drivers loaded into cabs I built. Cabs are painted (not the best), and have Speakon connections. Cabs measure 24hx17wx17deep. Connection on 2 cabs is 8 pole in, 4 pole out and 2 pole out. On the other two there is a single 2 pole in. 8 pole in cabs have a large (40uf?) cap inline with one of the 4 pole out wires. Hope that makes sense. A couple of the drivers have some light scratches from cats, but not enough to impede function, nor have I seen anything in measured data to suggest otherwise. Will NOT part drive units from cabinets and will NOT ship. Pickup near Rochester, MN is required.
 

Attachments

  • 1551646610810205.jpg
    1551646610810205.jpg
    512.9 KB · Views: 986
Last edited:
$600 for 4x TD15M 4 ohm drivers loaded into cabs I built. Cabs are painted (not the best), and have Speakon connections. Connection on 2 cabs is 8 pole in, 4 pole out and 2 pole out. On the other two there is a single 2 pole in. 8 pole in cabs have a large (40uf?) cap inline with one of the 4 pole out wires. Hope that makes sense. A couple of the drivers have some light scratches from cats, but not enough to impede function, nor have I seen anything in measured data to suggest otherwise. Will NOT part drive units from cabinets and will NOT ship. Pickup near Rochester, MN is required.

I'd be all over this if I were local even though I don't need them. GLWS.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.