Thanks!
My comments:
- I never use zeners as reference for CCS's. They are noisy! Signal diodes (1N914/1N4148) are much better here.
- C1 and C5 aren't needed.
- A Zobel (10ohm+100n) is needed on the output. (Maybe on the PCB there is a zobel, I haven't checked it...)
Anyway your desing will works.
Regards,
My comments:
- I never use zeners as reference for CCS's. They are noisy! Signal diodes (1N914/1N4148) are much better here.
- C1 and C5 aren't needed.
- A Zobel (10ohm+100n) is needed on the output. (Maybe on the PCB there is a zobel, I haven't checked it...)
Anyway your desing will works.
Regards,
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.