You could use a generic method.
1/ Turn bias right down and connect a speaker.
2/ Apply 100mV sine wave.
3/ Monitor output with a scope.
4/ Turn bias up slowly until cross over distortion goes.
I design my own amps so there is no special setup, I just use the above method and seems to work fine for push-pull or Quasi.
1/ Turn bias right down and connect a speaker.
2/ Apply 100mV sine wave.
3/ Monitor output with a scope.
4/ Turn bias up slowly until cross over distortion goes.
I design my own amps so there is no special setup, I just use the above method and seems to work fine for push-pull or Quasi.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.