You have to test the power output transistors
And then the drivers... and then continue to the smaller ones.
Supply and power transistors are always in the top of the list when we have burned fuses...there are other causes,but for sure those are the main ones.
You need to desolder 2 of the transistor leads...one can be keept into the printed board and test them.
Check also your power supply rectifiers and observe the condensers if warm, and check if something is dark, burned, smelling bad or something.
I could find the TA-F30...... maybe this can help you...there's a chance that only voltage will be different...maybe also the output transistors different.
May be helpfull to some start of debugging.
regards,
Carlos
And then the drivers... and then continue to the smaller ones.
Supply and power transistors are always in the top of the list when we have burned fuses...there are other causes,but for sure those are the main ones.
You need to desolder 2 of the transistor leads...one can be keept into the printed board and test them.
Check also your power supply rectifiers and observe the condensers if warm, and check if something is dark, burned, smelling bad or something.
I could find the TA-F30...... maybe this can help you...there's a chance that only voltage will be different...maybe also the output transistors different.
May be helpfull to some start of debugging.
regards,
Carlos
Attachments
Sony
Here :
Regards zeoN_Rider
Here :
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
Regards zeoN_Rider
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.