Hello everyone here, I am going to make custom Amplifier for speakers. I know very well about computer hardware but limited to circuits and all about parts of electronics.
What I Have?
Desktop 2GB ram, Dual core 2.8, On board Audio
Speakers 2.1ch
Inputs
Stereo input (RCA)
Control Panel Functions
Volume, Bass & Treble Controls
Sub-Woofer
1 Sub-woofer
Speakers
2 Satellite speakers
Total RMS Power Output
40 Watts RMS max.
Sub-Woofer RMS Power
20 Watts RMS max.
Satellite RMS Power
10 Watts RMS each
Sub-woofer Driver Unit
4.5 inch Full range woofer driver
Satellite Driver Unit
3 inch Full range speaker driver
Frequency Response
Woofer - 20Hz~200Hz, Satellites - 100Hz~20kHz
Separation
>= 45dB (1KHz)
S/N Ratio
>= 68dB
Separate 4 speakers from giant Old TV
What I Have Done?
I have broken amplifier circuit board in Sub-Woofer. Everything is fine beside green circuit board which is broken too badly and it can't be repaired
What I Want To Do Now?
1 I want to make it work again by putting high quality custom amplifier circuit board for best sound possible or Build separate amplifier and attach whole setup with it
2 Optional - Is it possible to make 5.1 ch systems as i have 4 separate speakers, sound very good.
What I Want To Know?
There are many types of amplifiers. Can you post info or useful links for classification, pros and cons all of them.
Note - Move My Thread to Appropriate Category if Posted in Wrong Section.
What I Have?
Desktop 2GB ram, Dual core 2.8, On board Audio
Speakers 2.1ch
Inputs
Stereo input (RCA)
Control Panel Functions
Volume, Bass & Treble Controls
Sub-Woofer
1 Sub-woofer
Speakers
2 Satellite speakers
Total RMS Power Output
40 Watts RMS max.
Sub-Woofer RMS Power
20 Watts RMS max.
Satellite RMS Power
10 Watts RMS each
Sub-woofer Driver Unit
4.5 inch Full range woofer driver
Satellite Driver Unit
3 inch Full range speaker driver
Frequency Response
Woofer - 20Hz~200Hz, Satellites - 100Hz~20kHz
Separation
>= 45dB (1KHz)
S/N Ratio
>= 68dB
Separate 4 speakers from giant Old TV
What I Have Done?
I have broken amplifier circuit board in Sub-Woofer. Everything is fine beside green circuit board which is broken too badly and it can't be repaired
What I Want To Do Now?
1 I want to make it work again by putting high quality custom amplifier circuit board for best sound possible or Build separate amplifier and attach whole setup with it
2 Optional - Is it possible to make 5.1 ch systems as i have 4 separate speakers, sound very good.
What I Want To Know?
There are many types of amplifiers. Can you post info or useful links for classification, pros and cons all of them.
Note - Move My Thread to Appropriate Category if Posted in Wrong Section.
Last edited: