My bad.
It is a DPST SW.
But from the schematics and the filter PCB board, it looks that a DPST could work. I might be wrong.
I just checked the PCB, the speaker is short to GND without power.
I still have grievances with this switch. If I don't switch it off fast enough (like smacking it) I get a disturbing Pop! in my precious vintage compression drivers. Does anybody know a switch that switches off with maximum effort?
Something like this: GRS-4021-0004 CW Industries | Mouser
exactly
Double Position Single Throw
what I'm always translating to my self as Dual Section Single Throw ..... or even simpler - Dual Section On-Off
no need for more oomph, just second section, which will give delay to shorting relay during turn On, and immediate shorting of relay during turn Off
Measure the rectangular cutout on the chassis rear panel and order a double pole switch which fits that rectangle.
I still have grievances with this switch. If I don't switch it off fast enough (like smacking it) I get a disturbing Pop! in my precious vintage compression drivers. Does anybody know a switch that switches off with maximum effort?
There is always a thump, I was just trying to keep it down to a dull roar.
However just for you I have an alternative switch arrangement to try,
which should shut the relay off faster.
Attachments
And you didn't have to sit on hold waiting for Customer Service to connect you to Technical Assistance!
There is always a thump, I was just trying to keep it down to a dull roar.
However just for you I have an alternative switch arrangement to try,
which should shut the relay off faster.
Thank you so much for the help! Just to confuse things, does it work on the P-channel amp as well? I aquired both through various donations and back alley deals.
The one used is Lamb 10A 125V / 250V, and the hole in the chassis measures 20x12mm, for future reference.
Attachments
Last edited:
Here we go again
To be clear, it is the EU P channel version I am experiencing the pop. Sorry for not declaring that sooner.
Forgot to show the moved resistor.
To be clear, it is the EU P channel version I am experiencing the pop. Sorry for not declaring that sooner.
Forgot to show the moved resistor.
Attachments
Last edited:
Anybody tried Innovation Cooling IC Graphite Thermal Pad (90 x90 mm) ?
Was thinking of using for OS to heatsink. Just looking for some feedback. It’s expensive.
Thanks
Was thinking of using for OS to heatsink. Just looking for some feedback. It’s expensive.
Thanks
You might even save $4 from using a regular thermal paste. Unles you plan to mount and unmount it 20 times. More of a novelty. Source: Thermal Paste vs. Reusable Graphite Thermal Pad Benchmarks (IC Diamond Pad) - YouTube
Last edited:
The smaller surface area of the pad will be a significant detriment to heat transfer. Even if the pad is 2x more efficient (it isn’t) you will still have issues moving the heat from the bracket to the heatsink.
The included paste will cover the entirety of the thermal interface. Use it, works wonderfully.
The included paste will cover the entirety of the thermal interface. Use it, works wonderfully.
I aquired both through various donations and back alley deals.
Are they indistinguishable sound-wise?
- Home
- Amplifiers
- Pass Labs
- DIY Sony VFET pt 1