blacklight said:
Thanx for the link. I also fond this one, very good quality, still need to know how to adjust these POT's for best results.
An externally hosted image should be here but it was not working when we last tested it.
I'm sure you'll find the answer in this link:
http://www.fenderforum.com/forum.html?db=&topic_number=410860&lastpost=2004-04-2619:15:57&offset=0
/Hugo
http://www.fenderforum.com/forum.html?db=&topic_number=410860&lastpost=2004-04-2619:15:57&offset=0
/Hugo
With a shorting on the input... or no input at all; connect a voltmeter from plate to plate (pin 3) on the output tubes. With the amp warmed up well, adjust the matching pot for zero volts. This matches the idle current (basically) through the tubes.
If the tubes are new, you may want to do this again after tubes have some hours on them.
With that done... simply adjust the hum balance for minimum audible hum at the speaker.
If the tubes are new, you may want to do this again after tubes have some hours on them.
With that done... simply adjust the hum balance for minimum audible hum at the speaker.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Live Sound
- Instruments and Amps
- Fender Adjustments