|19th June 2019, 06:27 AM||#1|
Join Date: Jul 2002
Location: Launceston, TAS, Australia
Gain Block One Low Noise Preamp
This is a Class A gain selectable stereo preamplifier, four basic gain settings can be selected individually per channel, from a gain of 2, 3, 4.5 and 7.5, at very low noise and THD, SNR of -122dB and THD of 0.0006% and biased into full Single Ended Class A output, with input and output couple using high quailty film capacitors.
Designed to be used between a RIAA Phono amp or used to boost the output of your high end DAC or any other application where extra Hi End gain is required in your sound system.
The power supply for the Holton Gain Block One is a fully electronic balanced supply with 3 levels of PI DC filtering before the main regulators, ensuring a low noise smoothed DC supply feeding the electronic regulators supplying the main Class A preamplifier.
Signal to Noise Ratio at the following switchable output gain levels.
17.6dB - 7.6 Gain -122dB SNR
12.6dB - 4.2 Gain -122dB SNR
8.9dB - 2.8 Gain -122dB SNR
6.0dB - 2.0 Gain -122dB SNR
Frequency response 2hz to 500khz -3dB
THD+N 0.0006% (-106dB)
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|MingDa MC-7R noise and gain||hirafu_boarder||Tubes / Valves||83||23rd January 2020 07:54 AM|
|FS SYMASYM dual block amp + preamp and cables||cucicu||Swap Meet||1||10th November 2014 07:48 AM|
|DIY Project - preamp-gain causes noise||Cypheron||Instruments and Amps||41||15th June 2012 04:54 PM|
|gain block pcb's||indianajo||Analog Line Level||3||17th September 2010 02:01 PM|
|Designing a phono pre. #1: high gain block||Onvinyl||Analog Line Level||11||6th November 2007 07:16 AM|
|New To Site?||Need Help?|