Just finished designing my op amp HPA, feel free to comment.
My power supply is sigma22 which gives +/- 15V to the amplifier PCB. I am going to use 100uF parallel with 0.1u film cap for power rails bypassing, is it enough?
- DC servo output resistor changed to 47k as suggested by sgrossklass
- Leave a place for compensation cap in case required
- Two JFET form a CCS and bias the op amp to class A
My power supply is sigma22 which gives +/- 15V to the amplifier PCB. I am going to use 100uF parallel with 0.1u film cap for power rails bypassing, is it enough?
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.