How do i fold a MLTL

[superlian]

If i have MLTL i like.

How do i fold it?

I understand that the volume should be the same and that the c/c of the driver and port should have the same distance from the top and bottom inside.

But what about the length?

And can i place the port on the side or even one on each side?

 

[planet10]

Adding the bend will add some length to the line, getting it right can be a bit tricky.

A fold will also add another LP filter to the line (not a bad thing), but leaving out corner reflectors (recommended) means the box will be a bit bigger volume.

As long as Z_d and Z_vent remains the same you can put them on whatever side you want (ignoring differences in room loading).

Here is what i ended up with when i folded the Woden ML-TL into a shorter/deeper form so that a seperate midTweeter box placed on top would be at an ear level.

http://wodendesign.com/downloads/Woden-A12pw-MLTL-plan.pdf
http://wodendesign.com/downloads/A12pw-folded-ml-tl-extents.pdf

For some reason i did put some deflectors on the folded line, probably for bracing and with the fold at the top pushing the volume up too much.

dave

 

[superlian]

Thank you. I think that will work

 

[Bjohannesen]

Measure the length of the line in the middle of the cross section all the way.