Break-in methods for new drivers?

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
Zvu

Zvu

Member
Joined 2009
I used 12V/1A transformer - conected drivers in series out of phase facing each other. Pair of 33 ohm resistors in series with drivers. I turned them on and went to work. After couple of days measured ts parameters came close to the factory specs.

I guess that PRO woofers and PRO midranges tend to stiffen up in time due to layer of resin that covers cloth surrounds.
 
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom