If you don't have any shorted or open source resistors or if you did, you must have some damage in the protection circuit.
I am assuming you metered the resistors in the area around the blown outputs?
Check the 1A and 2A transistors as well.
If there is a fault sometimes the bias wont set properly.
What resistance do you get from source to drain on each of the outputs?
Its likely a shorted diode marked 5D.
I am assuming you metered the resistors in the area around the blown outputs?
Check the 1A and 2A transistors as well.
If there is a fault sometimes the bias wont set properly.
What resistance do you get from source to drain on each of the outputs?
Its likely a shorted diode marked 5D.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.