Gooday all,
Can somebody plse show me in the right direction for building an easy good quality preamp for hi fi use. I'm currently using an AVR's pre outputs and it is only putting out 250mv. I need at least 1V on the preamp output to drive my power amp to full volume. It would be good to have tone controls as well. I have got an old Nad 1000 monitor series preamp, but I would prefer to do a diy build.
The preamp will be connected between the AVR pre- out and the power amp.
Regards
Jan
Can somebody plse show me in the right direction for building an easy good quality preamp for hi fi use. I'm currently using an AVR's pre outputs and it is only putting out 250mv. I need at least 1V on the preamp output to drive my power amp to full volume. It would be good to have tone controls as well. I have got an old Nad 1000 monitor series preamp, but I would prefer to do a diy build.
The preamp will be connected between the AVR pre- out and the power amp.
Regards
Jan
See here DP0209 project: http://www.diyaudio.com/forums/analog-line-level/218373-discrete-opamp-open-design-166.html
Any kits in addition to ESP .
(i have posted in the chip amp section also)
At this time looking for a preamp (prefer chip/opmap over discrete) for LM4780 build
with...
1. One analog unbalanced input to connect to a CD player source
and following controls
2. Volume
3. Bass
4.Treble
5.Balance
Thanks.
(i have posted in the chip amp section also)
At this time looking for a preamp (prefer chip/opmap over discrete) for LM4780 build
with...
1. One analog unbalanced input to connect to a CD player source
and following controls
2. Volume
3. Bass
4.Treble
5.Balance
Thanks.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.