|14th January 2015, 09:46 AM||#11|
Join Date: Sep 2001
Location: Melbourne, Australia
Dayne, this is absolutely true. I used the Philips codes, and therefore a universal remote with learning facility can pick up the instructions with some fiddling.
Because this aspect of the design is beyond me, I never did fully understand it. The genius who did it all, Ben, is now an extremely busy academic and just recently became a Father, so I an reluctant to impose on his time. Actually, along with the implementation issues with the GK1 I dropped it many years ago; service is difficult, and of course the multiple pcbs, microprocessor, the motor driven pot, additional power supplies and relays was a bridge too far for Aspen, particularly as preamps are no longer profitable for me.
This is a pity because I redeveloped a new analog version, the GK2, which was quite exceptional sonically, but cannot sell it for reasonable money considering the email service issues. I then put a lot of time into the design of the power amps, the NAKSA series, where I include all the technology to permit their use without a preamp to deliver the same sonic benefits. Reason: Very few audiophiles these days use phono and tape sources, a preamp with all its mechanical source switching is a waste, and the way the market is going just about everything will be driven from digital sources in the next years. Products like the Squeezebox were the new wave, and can deliver every source from an included remote!
Aspen Amplifiers P/L (Australia)
Last edited by AKSA; 14th January 2015 at 09:51 AM.
|14th January 2015, 10:23 AM||#12|
Join Date: Nov 2003
Location: Melbourne (Oz, not Florida!)
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Universal Remote for Forte F44||descartes||Solid State||8||27th January 2020 03:49 PM|
|FS AKSA GK pre-amp + remote||brubeck||AKSA||2||1st December 2013 01:53 AM|
|GK-1R earthing (again)||marcus1||AKSA||2||18th May 2011 05:43 AM|
|Universal Remote for Rotel RCD-855?||pjanda1||Digital Source||2||13th December 2007 03:07 PM|
|New To Site?||Need Help?|