Hi guys, appreciate taking your time to help out a noob here. Not sure if this is the right forum subsection, please move if it isn't.
I have an unusual project that I'm working on and I want to make sure that I'm doing it right. I'm using a Pyle PFA400U 8 ohm amplifier, four Dayton Audio exciters at 25W and 8 Ohm. All this is going into this human powered vehicle:
Is this the correct wiring sequence?
If not, can I please get a wiring diagram? I've gone through several of the cheap lepai's and I think it was because of how I had it wired, two leads going into one port, if that makes sense.
I'm sure there's more than meets the eye, might even be missing something. Regardless, I appreciate the help. Thanks.
I have an unusual project that I'm working on and I want to make sure that I'm doing it right. I'm using a Pyle PFA400U 8 ohm amplifier, four Dayton Audio exciters at 25W and 8 Ohm. All this is going into this human powered vehicle:
Is this the correct wiring sequence?
If not, can I please get a wiring diagram? I've gone through several of the cheap lepai's and I think it was because of how I had it wired, two leads going into one port, if that makes sense.
I'm sure there's more than meets the eye, might even be missing something. Regardless, I appreciate the help. Thanks.
- Status
- Not open for further replies.