I'm going to build a Pass Labs Clone and I want the board to be the best quality possible. I'm not looking for gold clad or anything, just good quality, pure copper clad.
C
C
Are you going to design your own board?
If so then you want a board production place?
Or do you want boards already made?
If so then you want a board production place?
Or do you want boards already made?
No, I'm going to build an X1000 Pass Labs amplifier. I will be designing my own board using circuit building software. I will need to take the board layout they suggest and etch my own boards....or possibly have someone else do it.
C
C
Consider the ghetto wing of Advanced circuits:
http://www.barebonespcb.com/
Although the 3@$33 special is quite excellant too
http://www.barebonespcb.com/
Although the 3@$33 special is quite excellant too
Both turn out good work at prices unemployed engineers can afford.
All depends if you want a solder mask and silk screen.
And how fast.
Jocko
All depends if you want a solder mask and silk screen.
And how fast.
Jocko
- Status
- Not open for further replies.