Hi,
I have posted this in the minidsp forum but thought I'd try it hear as well.
I have a 2x8, digi-vol, digi-FP with a 4x10 plugin.
When I try and upgrade the firmware the popup box says "Device not selected. Verify device is in bootloader mode". I can't find any reference to bootloader mode in the user manuals
When I press the green circle with round arrows - synchronise, it finds the device and gives me the box with 4 selections. I select "Upgrade & Synchronise" or "restore to default". Both give me the loading to board messages and seems to be writing to dsp but then a 2 selection box appears with "Restore factory setti" and Close application. I select the former and again it seems to be writing to dsp in the status bar.
I get the same 2 chice popup which goes on and on.
I have been using a minidsp 2x4 kit for the last 3 years with no problems so am surprised with this.
Thanks,
kffern
I have posted this in the minidsp forum but thought I'd try it hear as well.
I have a 2x8, digi-vol, digi-FP with a 4x10 plugin.
When I try and upgrade the firmware the popup box says "Device not selected. Verify device is in bootloader mode". I can't find any reference to bootloader mode in the user manuals
When I press the green circle with round arrows - synchronise, it finds the device and gives me the box with 4 selections. I select "Upgrade & Synchronise" or "restore to default". Both give me the loading to board messages and seems to be writing to dsp but then a 2 selection box appears with "Restore factory setti" and Close application. I select the former and again it seems to be writing to dsp in the status bar.
I get the same 2 chice popup which goes on and on.
I have been using a minidsp 2x4 kit for the last 3 years with no problems so am surprised with this.
Thanks,
kffern
Last edited: