Opening an old thread.
I have found a couple of these old Silicon Chip/Altronics Ultra-LD Mk3 kits and built them. The amplifiers sound really good but I have a small issue. The gain of one of the amp is sligtly higher than the other one. Any suggestions on how to match them. Is there any way to adjust the gain? I am using them to drive the front speakers in my home theatre. The source is the front channels preout of the Yamaha RX-V6A AV receiver.
Thank you.
I have found a couple of these old Silicon Chip/Altronics Ultra-LD Mk3 kits and built them. The amplifiers sound really good but I have a small issue. The gain of one of the amp is sligtly higher than the other one. Any suggestions on how to match them. Is there any way to adjust the gain? I am using them to drive the front speakers in my home theatre. The source is the front channels preout of the Yamaha RX-V6A AV receiver.
Thank you.