TSE-II Inverted Assembly

[tubularfluxus]

I have just started soldering parts on a TSE-II board.

Can I do inverted assembly, i.e. just the sockets on the top side of the board (the one where TUBELAB TSE-II is printed), and place all the rest of the parts on the other side?

How about Mosfet and other semiconductors? Will I run into issues with polarity and heath-sink position?

Thanks

 

[tubularfluxus]

Photos attached

 

[robgobson]

Take a look at this post in the main thread: https://www.diyaudio.com/forums/tubelab/331038-14-run-tse-die-26.html#post5803744

 

[tubularfluxus]

Great! thank you so much!