Does anyone know where I can obtain a schematic for my ancient Technics SA310?
This unit had a hum out of right channel which ended up burning the braided wire going from terminal to voicecoil on my speaker. So I replaced both of the output electrolytic capacitors(RH,LH). Put it back together, but now the digital display doesn't come on.
So back to the drawing board.
Anyhelp would be appreciated. Thanks.
This unit had a hum out of right channel which ended up burning the braided wire going from terminal to voicecoil on my speaker. So I replaced both of the output electrolytic capacitors(RH,LH). Put it back together, but now the digital display doesn't come on.
So back to the drawing board.
Anyhelp would be appreciated. Thanks.
I found technics SA410
May be helpfull... sometimes can be.
Take a look in "www.schematicsforfree.com" "audio amplifiers"
"products".....or "integrated amplifiers"..... you will find it there.
I was reading all again... and them found you.
regards
Carlos
May be helpfull... sometimes can be.
Take a look in "www.schematicsforfree.com" "audio amplifiers"
"products".....or "integrated amplifiers"..... you will find it there.
I was reading all again... and them found you.
regards
Carlos
- Status
- Not open for further replies.