Hello again,
Having more and more questions
I have obtained Soundeasy V23.0 over a year ago. I tried to walk myself through the speaker measurement process using the Guide N4 by Music and Design but did not have any success in the overall process. Some things seemed right but some were off.
At the moment I have a speaker that needs a passive filter, I was playing around with a DSP and figured that the best would be a BW6 filter @ 2300Hz for both woofer and tweeter. The tweeter has a low resonance freq of 720Hz so I think 2,3kHz would be sufficient not to blow it.
I have measured the necessary delay for the tweeter to be 0.21ms
I would like to use a lattice delay network.
As I already have an RTA measurement and the delay, I am hoping I could just use this input screen from Soundeasy to calculate a delay network?
Is this correct?
Having more and more questions
I have obtained Soundeasy V23.0 over a year ago. I tried to walk myself through the speaker measurement process using the Guide N4 by Music and Design but did not have any success in the overall process. Some things seemed right but some were off.
At the moment I have a speaker that needs a passive filter, I was playing around with a DSP and figured that the best would be a BW6 filter @ 2300Hz for both woofer and tweeter. The tweeter has a low resonance freq of 720Hz so I think 2,3kHz would be sufficient not to blow it.
I have measured the necessary delay for the tweeter to be 0.21ms
I would like to use a lattice delay network.
As I already have an RTA measurement and the delay, I am hoping I could just use this input screen from Soundeasy to calculate a delay network?
Is this correct?