I want to run a CS3310 pre amp chip through an ADAU1701 DSP to a 4 channel TPA3255 amp board in an aluminum case. I still have some odds and ends to get but I basically have the concept and major parts together.
I have super basic questions about assembly though. Do I need to use any specific material for the chip mounts? What do I need to do, if anything, about grounding? The three chips have 3 different kinds of power transformations (36VDC for the amp, 12V AC for the preamp and 7-12VDC for the DSP)...... is there any potential for interference/noise after these conversions that I can mitigate? Etc. I have assembled PCs and crossovers so I have some experience but this is a different animal. Just looking for very basic advice to make this go smoothly.
I have super basic questions about assembly though. Do I need to use any specific material for the chip mounts? What do I need to do, if anything, about grounding? The three chips have 3 different kinds of power transformations (36VDC for the amp, 12V AC for the preamp and 7-12VDC for the DSP)...... is there any potential for interference/noise after these conversions that I can mitigate? Etc. I have assembled PCs and crossovers so I have some experience but this is a different animal. Just looking for very basic advice to make this go smoothly.
Last edited:
