Rane HC4-SDR Headphone Amplifier from newbee

[aparatusonitus]

I have combined Rene HC4 and John Conover Spatial Reduction headphone amplifiers to avoid "super stereo effect" while listening headphones. Headphone amplifier should provide sufficient power to 32-300 Ohm headphones and accept SE and balance input. Crossover frequency for high and low active filters is about 700 Hz. I have little knowledge in electronics so I have to ask more experience builders whether this circuit is going to work or not? You can find mine and reference circuit in links below. Any comment are wellcome.

http://img19.photob...Amplifier_MkII.png

http://www.rane.com/pdf/hc4sch.pdf

http://www.johncon.com/john/SSheadphoneAmp/

 

[jcx]

cruise HeadWize for "crossfeed" or "spatializer" circuits, there are diy projects with good directions and active support on the diy forum there

http://headwize.com

 

[aparatusonitus]

Thanks jcx, done that allready, tring to get support from both sides😉.