I have a Provision PRTV800VT 8" touchscreen LCD that I purchased used. The 2 RCA inputs work fine, but the VGA cable was unplugged and a wire broken at the monitor end. It is on a 7 pin flat connector. I repaired the wire but when I went to plug it in inside the monitor case, the reception plug is a flat 9 pin. With 2 extra pins on the monitor there are 3 possible ways for me to plug it in. Does anybody have the pinout for this unit? I really want to get this unit installed in the car. I called Provision in Huston, but they were no help at all, couldn't even sell me a new cable. :Sigh:
Any help or insight would be greatly appreciated!
Any help or insight would be greatly appreciated!
- Status
- Not open for further replies.