I have been using a Proceed HPA3 and I am told the designers put a few pieces too close together that don't normally like/can stand high heat. Anybody familiar with these amps?
Thanks,
Nate
Thanks,
Nate
In the same boat
Sorry to resurrect an old thread, but I am in the same boat.
I have an HPA3 with a blown center channel. I have been desperately looking for information on this amp. Of particular interest is any information on heat-sensitive components that I can upgrade on the other 2 channels... hopefully reducing the chances for another dead channel.
Any info, suggests or tips? Thanks in advance.
fteixeira
Sorry to resurrect an old thread, but I am in the same boat.
I have an HPA3 with a blown center channel. I have been desperately looking for information on this amp. Of particular interest is any information on heat-sensitive components that I can upgrade on the other 2 channels... hopefully reducing the chances for another dead channel.
Any info, suggests or tips? Thanks in advance.
fteixeira
- Status
- Not open for further replies.