hi Folks,
I have a dead Velodyne F-1000-B subwoofer and there's no voltage coming out of the transformer. I'm looking for a schematic diagram for this model so that I can find an appropriate replacement transformer. Any pointers greatly appreciated!
Page
I have a dead Velodyne F-1000-B subwoofer and there's no voltage coming out of the transformer. I'm looking for a schematic diagram for this model so that I can find an appropriate replacement transformer. Any pointers greatly appreciated!
Page
Velodyne F-1000 Transformer
I have a plate amp from a Velodyne F-1000. It looks good, powers up and shows 33.1-0-33.1 volts at the AC side of the rectifier- no load. The numbers on the trans shield casing are 51-1200 / 23235 / P-4954, for what its worth. The DC rails show 45 volts or so.
It powers up and doesn't overheat, etc. I don't mean to violate any DIY rules about selling stuff, but I was researching, prior to auctioning the amp "NOT WORKING / FOR PARTS" (Since I have no woofer and I'm unable to tell if the servo circuit is operational). If you want it I'll send you the whole plate amp, cheap! Let me know if it's still on your radar.
I have a plate amp from a Velodyne F-1000. It looks good, powers up and shows 33.1-0-33.1 volts at the AC side of the rectifier- no load. The numbers on the trans shield casing are 51-1200 / 23235 / P-4954, for what its worth. The DC rails show 45 volts or so.
It powers up and doesn't overheat, etc. I don't mean to violate any DIY rules about selling stuff, but I was researching, prior to auctioning the amp "NOT WORKING / FOR PARTS" (Since I have no woofer and I'm unable to tell if the servo circuit is operational). If you want it I'll send you the whole plate amp, cheap! Let me know if it's still on your radar.
- Status
- Not open for further replies.