First and foremost I am an engineer. After that I am an amatuer race car driver and amatuer loudspeaker builder
I am not a great work worker by any means
How do you make these baffle cuts? I plan on glueing up a couple pieces of 3/4" plywood for this front baffle. I just don't know how to make the cuts. A link to a youtube video is entirely acceptable if this is something that is easily done.
I have:
A table saw
A circular saw
A track saw
A chop saw
A jig saw
A big stand mount belt sander
A handheld planar
A handheld belt sander
3x 350mm cube 3d printers and a butt load of CAD experience so I can make whatever jig I might need for this
What I don't have:
The knowledge to know how to make these cuts
The cut in question
I am not a great work worker by any means
How do you make these baffle cuts? I plan on glueing up a couple pieces of 3/4" plywood for this front baffle. I just don't know how to make the cuts. A link to a youtube video is entirely acceptable if this is something that is easily done.
I have:
A table saw
A circular saw
A track saw
A chop saw
A jig saw
A big stand mount belt sander
A handheld planar
A handheld belt sander
3x 350mm cube 3d printers and a butt load of CAD experience so I can make whatever jig I might need for this
What I don't have:
The knowledge to know how to make these cuts
The cut in question
