Hello, I am new to the Hypex family but am very excited to be evaluating
these amps! First off, I have the Nc500 and Nc500 adapter pcb powered
by the smps 1200, set with the jumpers unregulated, I have spoke with
hypex a number of times and they have confirmed I have connected
everything properly, but as soon as I power on the unit the overcurrent
led comes on and stays on and audio cuts out after about 5 seconds.
the nc500 input adapter card is jumped for buffered input from factory
and I have not changed and settings. Any insight would be a great help!
Second Question I also have 2 Udc2kw amps ran from a smps 3K,
those are running fine but even at less than 10 watts output they
run extremely hot (I am waiting on some huge heat-sinks.) is this
normal? Thanks! N
these amps! First off, I have the Nc500 and Nc500 adapter pcb powered
by the smps 1200, set with the jumpers unregulated, I have spoke with
hypex a number of times and they have confirmed I have connected
everything properly, but as soon as I power on the unit the overcurrent
led comes on and stays on and audio cuts out after about 5 seconds.
the nc500 input adapter card is jumped for buffered input from factory
and I have not changed and settings. Any insight would be a great help!
Second Question I also have 2 Udc2kw amps ran from a smps 3K,
those are running fine but even at less than 10 watts output they
run extremely hot (I am waiting on some huge heat-sinks.) is this
normal? Thanks! N