hi yall
So SUPER new to all this. Discovered DIY'ing speakers while researching on upgrading my speakers with big box store ones.
Been doing a lot of digging, reading, playing with Vituix, etc...
So im building a 4ohm LCR MTM soundbar. Each channel will be the same MTM setup essentially.
I decided on the new Dayton DMA80-8 (2 in parallel) for mid drivers and ND25FA-4 for the tweets. Was thinking of crossing at around 3k.
There are no ZMA or FRD files yet for the DMAs so I did a SPL and Z trace in Vituix and tried to mess around with it in Vituix.
My plan is to build a 2-way 2nd order crossover. I'm having a hard time getting it to cross around 3k-ish. I'm getting around 4800ish and also not as flat a SPL as I'd like. Anyone try the new DMAs and designing a crossover?
So SUPER new to all this. Discovered DIY'ing speakers while researching on upgrading my speakers with big box store ones.
Been doing a lot of digging, reading, playing with Vituix, etc...
So im building a 4ohm LCR MTM soundbar. Each channel will be the same MTM setup essentially.
I decided on the new Dayton DMA80-8 (2 in parallel) for mid drivers and ND25FA-4 for the tweets. Was thinking of crossing at around 3k.
There are no ZMA or FRD files yet for the DMAs so I did a SPL and Z trace in Vituix and tried to mess around with it in Vituix.
My plan is to build a 2-way 2nd order crossover. I'm having a hard time getting it to cross around 3k-ish. I'm getting around 4800ish and also not as flat a SPL as I'd like. Anyone try the new DMAs and designing a crossover?