Dear,
A question. Let's say you design a stereo amplifier, and you want the left channel PCB mirrored to the right channel PCB. How to mirror a complete PCB design in Eagle. Is this possible?
Many thanks in advance.
With kind regards,
Bas
A question. Let's say you design a stereo amplifier, and you want the left channel PCB mirrored to the right channel PCB. How to mirror a complete PCB design in Eagle. Is this possible?
Many thanks in advance.
With kind regards,
Bas
can't be done - mirroring would require 3 or more terminal parts with mirrored pinouts
you can "mirror" parts placement but the wiring will have to be done again by hand
for a weird looking option you could flip the layout and stuff the other side
but most people settle for just repeating the block and putting it down beside the other channel
you can "mirror" parts placement but the wiring will have to be done again by hand
for a weird looking option you could flip the layout and stuff the other side
but most people settle for just repeating the block and putting it down beside the other channel
- Status
- Not open for further replies.