I need to see a pulse response from I/V converter, but how to configure a rectangular/triangular signal source from current output DAC (+/-2mA) in LT SwCAD?
component>current
rt clik body: >advanced>pulse
fill in pulse description
while the LtSpice help is very good, questions this basic may be easier to find in an introductroy spice modeling book or tutorial - yahoo group for LtSpice is a good resource too (must register though)
rt clik body: >advanced>pulse
fill in pulse description
while the LtSpice help is very good, questions this basic may be easier to find in an introductroy spice modeling book or tutorial - yahoo group for LtSpice is a good resource too (must register though)
- Status
- Not open for further replies.