Looking for someone that can design parts for me from time to time PAID in EagleCAD 7, I often need a part made, or adjusted and I have not had time to sit down and figure it out for myself, Willing to pay someone that can do it for me. either by the hour or by the part.
Please message me if you can help
ZC
Please message me if you can help
ZC
I am once again looking for some help designing a part for eaglecad. its a simple 4PDT switch. can anyone help? willing to pay
i am stuck on eagle for now. I have looked at KiCad which seems to be what everyone is going to. just another thing i need to learn that i don't have time for at the moment. I need to spend the bucks and by Altium and just learn that if i am going to invest the time into something. But for now. eagle i can get around quick in except when i need a part such as this. I see that now most parts suppliers have downloadable parts librarys which is great. but for whatever reason C&K does not have any available! some one help me out please
Every ecad system has the same issue where you have create custom symbols and associated footprints. Especially mechanical parts. It’s just something you have to spend time and learn to do.
There are companies out there that offer these services but I can’t name any off the top since I do not use them and make them myself. It’s not that difficult from my experiences.
There are companies out there that offer these services but I can’t name any off the top since I do not use them and make them myself. It’s not that difficult from my experiences.
Look at the data sheet contact arrangement diagram for the pad layout.
The only tricky thing is the location of the footprint from the front edge of the board.
The only tricky thing is the location of the footprint from the front edge of the board.
right now I have more money then time. I DO need to learn to do this, but right now I have to get this project done. I need to hire someone to do this for me.
Search the internet using
@https://www.google.ca/search?q=pcb+footprint+creation+services&ie=UTF-8&oe=UTF-8&hl=en-ca&client=safari”
Here is one
https://www.samacsys.com/pcb-librarian-service/
@https://www.google.ca/search?q=pcb+footprint+creation+services&ie=UTF-8&oe=UTF-8&hl=en-ca&client=safari”
Here is one
https://www.samacsys.com/pcb-librarian-service/
thanks i will give it a try. i have pre autocad version however. will see if i can find some help there