I was looking to use the subwoofer by it's self so I found this online today
use Z680 sub on an standalone amp's "Pre-out"? - Logitech Z-680 - Neoseeker Forums
about halfway down the page they show how to do it... Well unless I missed something I ended up blowing up one TDA7293 chip.
My input (RCA) in connected to the amp board marked Sub assuming that's right I can't see what else I could of missed.
use Z680 sub on an standalone amp's "Pre-out"? - Logitech Z-680 - Neoseeker Forums
about halfway down the page they show how to do it... Well unless I missed something I ended up blowing up one TDA7293 chip.
My input (RCA) in connected to the amp board marked Sub assuming that's right I can't see what else I could of missed.
- Status
- Not open for further replies.