I made a small LM3875 amp some time ago, and I am getting a few board made. Is anybody here interested?
You can see my board here: http://stiftsbogtrykkeriet.dk/~mcs/LM3875/
The cost will probably be around $8-10 each.
Best regards,
Mikkel C. Simonsen
You can see my board here: http://stiftsbogtrykkeriet.dk/~mcs/LM3875/
The cost will probably be around $8-10 each.
Best regards,
Mikkel C. Simonsen
I have just bought 6 of the LM3875TF amps from Dantimax.
They are very straight forward to build and all components are top quality. I am sure these amps will bring me the best value for my money.
To power the amps I have 4 * 225VA toroidal transformers providing 2*22vac
I am very happy with the support and information I have gotten from Mikkel.
They are very straight forward to build and all components are top quality. I am sure these amps will bring me the best value for my money.
To power the amps I have 4 * 225VA toroidal transformers providing 2*22vac
I am very happy with the support and information I have gotten from Mikkel.
I have now built one of the amp, and I must say the parts are good quality and the sound of this amp is much better than what I expected, it even outperforms my old Yamaha amp.
It doesn't really get hot only slightly warm when played loud 😀
I cannot wait to buld the mono block I have in mind....
It doesn't really get hot only slightly warm when played loud 😀
I cannot wait to buld the mono block I have in mind....
- Status
- Not open for further replies.