Jordan JX92S MLTL-48 Front Baffle Question

Status
Not open for further replies.
Hi,

I am building the MLTL-48 enclosure for the JX92S driver out of 18mm (slightly under 3/4") ply. Once I router the recess for the driver and bevel the back of the driver cutout as per the recommendations will there be enough material to sufficiently hold the driver ? I'm still waiting on the driver to arrive but I am assuming about 4mm of recess.

An option would be to glue an additional piece of ply to the back of the baffle around the driver to provide some extra strength, though this would take up some internal volume - is this a issue ?

Thanks,
Dan
 
Status
Not open for further replies.