• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Integra DTR-10.5 / Onkyo TX-NR1000 Parts

Status
Not open for further replies.
Jump to Latest
john65b

john65b

Member
Joined 2005
#1
Hey all, I have some parts left over from a Integra DTR-10.5 (also a Onkyo TX-NR1000) strip down of a Home Theater Receiver - this thing was a monster - 90 pounds. The DSP board was dead, and unfortunately EVERYTHING goes thru this board...so I decided to strip it for parts...

Transformer - 5" diam x 5" high and weighs around 15 pounds.... Has 49-0-49, 22-0-22, 35-0-35 on secondary, and also has another connector with additional voltages. This was powering a 150 watts x 7 channels, so should be around 1KVA - and its potted - $50 + ship.

Power supply board for Transformer - rectifier is here, a bunch or relays, and separate monster Nichicon 33,000uf 80V Caps $25 + ship

Amp boards - these look to be Sanken MP150S / MN150S, but I cannot find any info on them - my guess is that they were rebranded for Onkyo / Integra... output device boards come installed on tunnel heatsinks. Also with the amp modules is the other two boards that come with the amp. $50 + ship

Or take the whole shebang for $100 + ship.

I also have the PDF of the service manual too...
 

Attachments

  • IMG_0400.jpg
    IMG_0400.jpg
    994.3 KB · Views: 290
  • IMG_0399.jpg
    IMG_0399.jpg
    1,011.9 KB · Views: 263
Last edited:
Status
Not open for further replies.
Top Bottom